PA 22 iPad Mounting

[Srlewis]

I installed the Stratus ESG ADAB in/Out. It works well and seamlessly links to my iPad. What I cant find is a really good place to mount the iPad. Any suggestions?
Thanks

[TDailing]

Guardian avionics makes an I Pad and I pad mini flush panel mount. https://www.guardianavionics.com/iPa...fied_c_30.html

I have been working on a panel overlay that will house the I pad mount. It’s made from .040 thick 3003 Aluminum.

Todd

[Srlewis]

Todd,
Thanks for the information, please post pictures of how it turns out

[181]

That's as good a place as any. I have mine suction cupped to the left side of the windshield. I don't like it there because it cuts down on visibility, but I didn't have a mount to put it anywhere else.

[TDailing]

Not going to use. Any interest in it?

I can put in the classifieds

[LarryV]

Not going to use. Any interest in it?

I can put in the classifieds

It's tempting but probably not.

We're going to re-do our avionics down the road to make our PA-22/20 IFR capable. However, we'll most likely start with a Garmin 430, a couple nav coms and an audio panel/intercom in the center stack, and run our iPad as an external unit off our Stratux.

[LarryV]

Robbed a ram mount from my motorcycle and my bike. What do you think?

Right now, pending the above mentioned avionics upgrade, we have our iPad mounted over the center stack - where there are no radios. *IF* were were just going to install a com, and a transponder and went with the Trig instrument hole mounted units, this would still work great. If we ultimately decide to keep it VFR only, we'll do a more permanent version of this.



The other alternative would be a yoke mount, but I'd put it on the right side yoke so it would not be blocking my view of the VSI, TC and altimeter in my panel.